Rhythmedics® Bio-Pulses Interrupt Harmful ElectroMagnetic Interference (EMI)

Oscilloscopic Comparisons to the SRT-3 Q-Link

 

Q-Link's pendant has been touted for its ability to transform harmful EMI (ElectroMagnetic Interference) into positive energy, supposedly enabling its wearer to stay energized and focused.  Q-Link is a passive device, which when viewed from the front appears to have a simple coil of copper wire wound around it center.  Rhythmedics Pendulum is an active instrument emitting Fibonacci based Bio-Pulses that actively interrupt harmful EMI.  NuTesla acquired a new SRT-3 Q-Link and using NuTesla's state-of-the-art laboratory conducted a series of tests comparing the measurable and viewable affects of both the Q-Link and Pendulum to disrupt EMI from three common household electrical products; A) 5.8 GHz Cordless Phone, B) 12 volt Plug-in Wall Transformer used to recharge electronic devices, and C) desktop fluorescent lamp's power supply.  Three images are displayed for each electrical product tested. The first image shows the raw EMI source, the second shows the EMI with the Q-Link between the probe and source, and the third shows the EMI with the Pendulum between the probe and source.  In every case the Q-Link shows no affect on the EMI, whereas the Pendulum clearly interrupts the EMI source.

 

 

1. CORDLESS PHONE EMI (First Image No Protection, Second Image Q-Link and Third Image Pendulum Bio-Pulses)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2. WALL TRANSFORMER EMI (First Image No Protection, Second Image Q-Link and Third Image Pendulum Bio-Pulses)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3. FLUORESCENT LAMP POWER SUPPLY EMI (First Image No Protection, Second Image Q-Link and Third Image Pendulum Bio-Pulses)

 

 

 

 

 

 

 

 

 

 

 

 

 

Notes: All measurements were made with a Tektronix TDS 3034 Digital Phosphor Oscilloscope.  A 10 milliHenry ferrite core inductor with a 10,000 ohm termination resistor was used as the probe.  Measurements were made at a distance of 1 inch from the EMI source to eliminate ambient EMI sources.  Once a raw EMI signal was captured on the digital oscilloscope, the SRT-3 Q-Link was inserted between the EMI source and the probe and the second image was captured.  Then the Pendulum was placed between the EMI source and probe and the third image was captured.  All settings for the Oscilloscope are displayed on its screen. 

Conclusion

The images above clearly show the Q-Link makes no observable changes to the EMI from common household sources.  Whereas the images clearly show the Rhythmedics Pendulum's Bio-Pulses interrupts the continuous EMI source.  This is critical as studies of EMI have shown it is necessary to disrupt the continuity of the EMI stream in order to prevent that aspect of it from adversely affecting the health of humans and animals.  All Rhythmedics Instruments create Bio-Pulses that effectively interrupts harmful EMI as shown above.

 

 HomeContactWellness ProductsPerformance ProductsProfessional ProductsArea Enhancement ProductsRhythmedics InfoCircadian Rhythm InfoCritical Flicker Fusion InfoFibonacci Numbers InfoOur TeamAbout Our LogoSafetyDisclaimer

 

NuTesla L.L.C. - All Rights Reserved

375 North Stephanie Street, Suite 1411, Henderson, NV 89014